1ns Bin Size Histogrammer, FPGA + ADC

$750-1500 USD

Cerrado

Publicado

hace casi 5 años

$750-1500 USD

Pagado a la entrega

I have a digital input measurement signal, 0 ~ 1.1V level. Each pulse is an event, that has a level HIGH width from 5ns to 10ns, and the minimum time between every 2 pulses' rising edges is 20ns. I need a system to histogram the time between all adjacent pulses' rising edges, that each bin of the histogram is 1ns wide. For example, starting from t=0, if the input signal has rising edges at t=3.2ns, 28.5ns, 528.6ns and 1528.7ns. Then in the histogram, Bin #25, Bin #500 and Bin #1000 have 1 respectively, and all other bins have 0s. SPEC: Bin Size: <=1ns # of Bins: Up to 10K What I need from you: 1. A plan on what I need to buy to build this system. I have a ZCU102 board. So maybe something like AD9234-LF1000EBZ? Do let me know your plan in your proposal. 2. The deliverable is the firmware, including ZCU102 PL side RTL and bit file, Petalinux Image and drivers. 3. Remote support, to set up the whole system. 4. A block diagram and a brief explanation about your RTL code. Verilog is preferred. Please in the proposal, let me know how long would the project take and how much would you ask to build it.

Electrical Engineering

Electronics

FPGA

Verilog / VHDL

ID del proyecto: 19314823

Información sobre el proyecto

1 propuesta

Proyecto remoto

Activo hace 5 años

¿Buscas ganar dinero?

Dirección de email

Beneficios de presentar ofertas en Freelancer

Fija tu plazo y presupuesto

Cobra por tu trabajo

Describe tu propuesta

Es gratis registrarse y presentar ofertas en los trabajos

1 freelancer está ofertando un promedio de $1.250 USD por este trabajo

@fjot

I think that the pulse delay measurement can be done without any external components. If your information about the pulses input level (0V - 1.1V) is correct, then LVCMOS12 (1.2V IO standard) could work with this. If the input signaling would be on the edge it would be possible to clean up the signal and convert to e.g. LVDS with an external high-speed comparator component. Xilinx UltraScale+ HP IO works up to 1250Mbit/s e.g. in case of RX SERDES. In case we run this with exactly 1000Mbit/s rate we could measure the pulses with +/-0.5ns accuracy. Still, from start to end measurement this probably results in +/-1ns ambiguity. Even Zynq Ultrascale is not needed, Zynq 7000 would do the job. Here I make this proposal to implement the pulse delay measurement using ISERDES approach: LVCMOS12 input -> ISERDES -> delay measurement -> RAM-based histogram The module would have AXI interface to the PS domain. My proposal is that I could implement the RTL and prove the operation using simulation, but I can't test it on HW and I cannot integrate it with SW/Linux.

$1.250 USD en 5 días