Greetings,
I'm an electrical & electronics engineer by profession with good amount of experience in hardware and system design.
17+ years of experience with, circuit design, simulation, analysis,prototyping & product design through certification.
I would like to present myself for electrical engineer opportunity.
Hardware Experience
-Discrete analog subsystem design;
-Board design & system engineering
-Custom Hardware Designs
-Product Knowledge in engineering fields of Electrical, software and mechanical
-EMI/EMC based design (RE,CE,RS &CS) and Compliance testing.
-Discrete analog subsystem design
-APQP to address DFM, DFT & Yield improvement
-High-speed microprocessor design- Power PC, MIPS, Xscale, and ARM based board designs;
DDR3/DDR4/QDR based designs.
-DSP/ micro controller/ Ethernet/ High-speed memory, I/O based design.
-Power Supply Design (<100W)
-CPLD/FPGA/Digital logic design/VHDL, programming.
-CMOS Transistor level design, realization, and Power optimization.
-UART/ RTC/ timers/ GPIO/ Memory map - Hardware diagnostics.
-TDM bus/ ST bus/ SPI/ 3-wire/ I2C/ RS-232/ RS-485 based board design.
-DFT (Design for testability) compliant with JTAG for on board hardware.
-Knowledge of different CPU architectures and their interfaces like PCI, PCIX, SATA, SCSI, USB and different I/O interfaces.
-DFSS (Design for Six Sigma) Green belt certified. Knowledge of six sigma based tools
-Circuit Analysis: Six Sigma, Worst case & RSS Analysis
-Mechanical packaging realization.