c/c++ programming for STM32 + 66WV51216DBLL + SSD1963

Hullo Bro , Thank you for inviting me to your project . Well , I have worked on almost all STM series , namely (STM32F103 , STM32F207 , STM32F407 and STM32F429I) . I have worked with external SDRAMs , SRAMs , NOR and NAND memories. I could also show you samples of my previous work on STM on my youtube channel. ----------------------------------------------------------------------------------------------------------------------------------------------------------- I have long experience with 8-bit , 16-bit and 32-bit micro-controllers. I work with Microchip (PIC) , Atmel (AVR , SAM) , ST (STM) , TI (MSP) and NXP (LPC) micro-controllers. I use KEIL IDE , Atmel Studio , Code Composer Studio and MPLABX IDE . I deliver tested , neat and well-commented code that can be reused or modified for future development. More to be discussed once you contact me . BR, M.T.

Hello. I'm an embedded software engineer with extensive experience in STM32 development. I've used the STM32F103 for several projects, that usually involve GUI development as well, so I'm quite familiar with it. I can provide the necessary interfacing you need with the OLED display and any supporting graphics library. I can also interface your parallel SRAM chip with the STM32. Contact me to discuss details.

Hello, i have read the details provided..please contact me to discuss more on the project deadline and some other few things

Hi iam working on stm32 to one of the freelancer and if you wish I will send you project id you may verify.. Iam going to complete it.. If you send me the requirements and schematics we can start.. All the payments are after your satisfaction and completion of phases..

I'm an electronic engineer with more than 15 years of work experience. I work as HW designer; FW and SW developer. As HW designer, I work in Altium, KiCad and Orcad and I have experience in development single MCU (Microchip PIC and ARM Cortex) boards with several digital I/O (GPIO, UART, SPI, I2C, PWM,....) and some analog I/O. I design complete board: power section, MCU section, peripheral section,.... I design also boards with battery power; so I have experience in low power PCB design. I have also experience in commercial boards (Arduino, Raspberry, Beaglebone,...) shields design. I have also experience in bluetooth (both 2.0 and 4.0) PCB design. As FW developer, usually I work in C for Microchip PIC (MPLAB X + XC compilers) and Eclipse + GNU ARM for different ARM Cortex M3/M4 manufacturers (STM32Fx, NXP, EFM32 SiLabs, but I'm ready to learn new frameworks). I work both single task and multi task environment (FreeRTOS and RTX). I write code both for low level driver (GPIO, UART, SPI, I2C, PWM....) management and for high level/final application. I work also in "C code" commercial boards Arduino/ESP8266 and Linux embedded commercial boards (Raspberry and Beaglebone). I have also experience in bluetooth (both 2.0 and 4.0) programming. As SW developer, I work in C, C++, .NET, Java, and lot of others programming languages. Mainly I work for Windows O.S., but I have experience in Linux development too. I have experience in openCV library for image/video processing.

Hello, i have 5+ years of experience with embedded c - most of the projects i worked on were based on STM32 series. I had to provide GUI (using QML c++) for most of these devices too. I think i can help you with your problem. If you are interested PM me. BR, Nejc