PIC IC Logic TEST

Hello, I'm looking for help to program a PIC16C774 microcontroller to apply inputs and aquire outputs to and from a simple logic device. The PIC is connected to a PC via an RS232 circuit (using MAX232 chip) and a serial cable. The device to be tested is a 'CD74HCT21E'. This is a Dual 4-input AND gate (two 4-input AND gates on one chip). The data sheet for this device is attached below in the addtional files section. On command from the PC, the PIC will apply inputs in a sequence consistent with the device truth table. It will then transmit the 2 device outputs back to the PC COM1 port. According to the truth table there will two sets of 5 outputs. I will use this information on the PC side to check that the outputs are correct. I will be using MS Visual Basic 6 when reading the device outputs from the COM port. Currently the PIC is connected to the AND device as follows: Pin1 - RB7; Pin2 - RB6; Pin3 - RB5; Pin4 - RB4; Pin5 - RB3; Pin6 -RB2; Pin7 - RB1. and Pin8 - RA3; Pin9 - RA2; Pin10 - RA1; Pin11 - RA0; Pin12 - RE2; Pin13 - RE1; Pin14 - RE0. The outputs from each input sequence must be available at the COM port after that sequence has executed. This will enable me to make proper logic comparisons on the PC side. ## Deliverables 1) Complete and fully-functional working program(s) in executable form as well as complete source code of all work done. 2) Deliverables must be in ready-to-run condition, as follows: A software installation package that will install the software in ready-to-run condition on the platform(s) specified in this bid request. 3) All deliverables will be considered "work made for hire" under U.S. Copyright law. Buyer will receive exclusive and complete copyrights to all work purchased. (No GPL, GNU, 3rd party components, etc. unless all copyright ramifications are explained AND AGREED TO by the buyer on the site per the coder's Seller Legal Agreement). ## Platform Microchip assembly language using MPLAB and the MPASM complier. Or in c.