We are looking for a SW devoloper for a small attiny project.
Hardware will be designed on our side.
The project is a small thermostat which is switching a heater element on and off.
The UI is two 7-segment Displays and 5 pcs switch buttons.
1 ON/OFF, UP/Down, Set/Enter, Start delay.
An IR Remote control is duplicating this interface.
Heater is controlled by GPIO on Attiny, for security reasons there is allso a tilt sensor in serial, which is also obsurved by an GPIO.
An NTC 10k is used to meassure the temperature.
Resolution 1°C, Accurency 2°C
Displayed Temperature: 0-40°C
Settable Temp: 7-28°C
Antifreeze: 7°C
SW should be written in C/C++. Documentation in english.
Hi,
I hope you are doing well. I have extensive experience with AVR Attiny microcontroller developing similar projects.
I have also hardware available for quick prototyping and testing.
I understand your requirement to thermostat controller with IR control.
I have understood your requirements and I can execute this project in less possible time.
Please send me message for further discussion.
Looking Forward,
Khawaja
Hi there , I am an electrical engineer with 19 years experience in this area. I am interested in your project ATTINY Thermostat with IR Remote, please send me a chat message , I have come questions and I need more details.
Rahul Soni
Hello, I am an experienced embedded system engineer (8 years+). I have programmed ATTINY and ATMEGA uC in the past. I am also a PhD candidate in Automation and Robotics. I can help you with your project. Thanks